Flowmeter for industrial process & control 

Published: 18-Aug-2021

Designed to IP65 standards Titan’s Process Atrato ultrasonic flowmeter is ideal for use in industrial process and control environments

Based on Titan’s standard Atrato meter, the Atrato Process is packaged to address more challenging environments. The body is 316 stainless steel, and the only other wetted materials are PEEK and the customer’s choice of elastomers.

Rated for use up to 65°C and 20Bar, the compact Process Atrato is available in four models operating within flow ranges from 2ml/min to 15litres/min, with an accuracy of ±1% over the whole flow range.

Calibrated at a pre-set 'K' factor, all Process Atrato meters of the same flow range are fully interchangeable, simplifying assembly and set-up procedures for OEM manufacturers looking to integrate the flowmeter into their process and control set-up.

Two multi-coloured LEDs display the flow meter’s system information. The upper LED displays signal condition, showing green, orange or red to indicate signal strength, while the lower LED shows information about the power supply and pulse output. If flow is present, this LED will flash to show a pulse output. The rate of flashing is related to the flow rate.

Relevant companies

You may also like